This Luxury Crochet Table Runner Pattern has a champagne-colored body of fan-shaped shells and airy arches, finished with a deep scalloped border and delicate picot trim. The stitches are simple, but the mercerized cotton, the crisp blocking, and the picot edge give it the look of a boutique piece. Use it on a dining table, a console, or a sideboard, or give it as a wedding or housewarming gift.

Pattern Information

Skill level: Advanced beginner to intermediate, with simple lace and edging.
Terms: US crochet terminology.
Construction: The body is worked flat in turned rows from a long foundation chain. A scalloped border with picot trim is then worked around the whole piece in joined rounds.
Estimated size: About 22 × 92 cm (9 × 36 in) after blocking, including the border. Actual dimensions depend on yarn, tension, and blocking.
Pattern note: This is an original design based on the title concept. Stitch counts have been checked, but the pattern has not been physically crocheted or independently tested. Make a small swatch first and adjust the hook size to your tension.

Materials

  • DK-weight mercerized cotton yarn in champagne, ivory, or soft white, approximately 150–200 g as a starting allowance.
  • A 3.5 mm hook as a starting point (adjust to your tension).
  • Tapestry needle, scissors, stitch markers, and pins.
  • Blocking mats, a spray bottle, and fabric starch (optional but recommended).
  • Optional: 68 small pearl beads (3–4 mm) and a very fine hook or beading needle for the pearl detail.

Stitches and Abbreviations

AbbreviationMeaning
chchain
sl stslip stitch
scsingle crochet
dcdouble crochet
spspace
picotch 3, sl st in the first ch
st(s)stitch(es)

The body is worked in turned rows. The border is worked in joined rounds. Numbers in brackets give the stitch count at the end of each row or round. Repeat parentheses or asterisks the stated number of times.

Before You Begin

Work Rows 1–4 as a swatch with a shorter chain (ch 26, which gives 25 sc and 6 arches). The arches should be open but not floppy. If they sag, go down half a hook size.

Why does it look expensive? Mercerized cotton has a soft sheen, a neutral color photographs and displays beautifully, and the final blocking with starch makes the lace crisp. Do not skip the blocking step.

To change the length, use a foundation chain of 4k + 2, where k is the number of arches per arch row. The border counts will change, so recalculate Border Round 1 (see the note after it).

Runner Body

Ch 178.

Row 1 (base): Sc in the 2nd ch from hook and in each ch across. Turn. [177 sc]

Row 2 (arches): Ch 1, sc in the first st. (Ch 5, skip 3 sts, sc in the next st) × 44. Turn. [45 sc, 44 ch-5 arches]

Row 3 (shells): Ch 1, sc in the first sc. (3 dc in the next ch-5 sp, sc in the next sc) × 44. Turn. [45 sc, 44 shells of 3 dc, 177 sts]

Rows 4–19: Repeat Rows 2 and 3 eight more times. You will have worked 9 arch rows and 9 shell rows in total. [177 sts per row]

Row 20 (closing row): Ch 1, sc in each st across. Do not fasten off. [177 sc]

Scalloped Border

Round 1 (foundation round): Ch 1, do not turn. Work 3 sc in the corner, then 21 sc evenly along the short end (one sc per row end, with 2 sc in one row end to make 21). Work 3 sc in the next corner, then 1 sc in each foundation chain along the long edge (177 sc). Work 3 sc in the corner, 21 sc along the second short end, 3 sc in the final corner, and 177 sc along the top edge. Join with a sl st to the first sc. [408 sc: 354 along the long edges, 42 along the short edges, and 12 in the corners]

Note: If you change the runner length or row count, make sure the total in Round 1 is a multiple of 6. Add or skip one or two stitches along the short edges to adjust.

Round 2 (scallops): Ch 1, sl st in the same st. (Skip 2 sts, 5 dc in the next st, skip 2 sts, sl st in the next st) × 67. Skip 2 sts, 5 dc in the next st, skip the last 2 sts, and join with a sl st to the first sl st. [68 scallops, 5 dc each]

Round 3 (picot trim): Sl st in each of the next 3 sts to reach the center (3rd) dc of the first scallop. (Sc, picot, sc) in the center dc, ch 3, sc in the sl st between scallops, ch 3. Skip 2 dc and repeat in the center dc of the next scallop. Continue around. Join with a sl st, fasten off, and weave in the ends. [68 picots]

Optional pearl detail: Before working Round 3, thread a bead onto the yarn for every picot. Slide one bead up to the hook just before each picot’s ch 3 and work the chain with the bead on its second stitch.

Finishing and Blocking

Wash the runner gently in cool water with a drop of mild soap, then press out the water in a towel without wringing. Pin it flat on a blocking mat, with the long edges straight, each scallop shaped, and each picot pinned out. Spray with diluted starch and leave it to dry completely before unpinning. For a very crisp finish, repeat the starch spray once.

Practical Tips and Troubleshooting

The edges curl. Your tension may be tight in the arch rows. Go up half a hook size or block more firmly.

The arches look uneven. Always skip exactly 3 sts and work the sc in the 4th. A stitch marker every 10 arches helps you catch a miscount early.

The runner is not straight. Count the stitches at the end of every shell row. The count should always be 177. If it is not, find the missing or extra shell before continuing.

The scallops do not lie flat. Check that Border Round 1 is a multiple of 6. If it is not, add or skip a stitch on a long-edge stretch rather than at the corners.

The runner is too narrow. Add rows in pairs (one arch row and one shell row) before the closing row. Each extra pair adds 2 sc to each short edge, so recheck the Round 1 total.

FAQ

Can I use thread instead of yarn? Yes. Use size 10 cotton thread and a 1.75 mm hook. The runner will be narrower, so add more rows, and recalculate the border.

Can I use another color? Yes. Soft grey, dusty rose, and sage green all look elegant. Avoid bright colors if you want the luxury look.

Do I need to block it? It is strongly recommended. Blocking is what gives the lace its crisp, professional finish.

Can I make it longer? Yes. Increase the foundation chain by multiples of 4 and recalculate the border counts.

More Free Crochet Patterns

  • Cottagecore Crochet Table Runner Pattern
  • Sunflower Crochet Table Runner Pattern
  • Crochet Lace Doily Pattern

Save This Pattern

Pin this Luxury Crochet Table Runner Pattern to your Pinterest board for your next lace project. Happy crocheting!

Leave a Comment

Follow Me

Top Selling Multipurpose WP Theme

Newsletter